Default-Metric - Dell S4810 Reference Manual

Version 7.7.1.0
Usage
To remove all configured debug commands for BGP, enter the no debug ip bgp
Information
command.

default-metric

Allows you to change the metric of redistributed routes to locally originated routes. Use this command
with the redistribute command.
S4810
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number
Defaults 0
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The default-metric command in BGP sets the value of the BGP
Information
MULTI_EXIT_DISC (MED) attribute for redistributed routes only.
Related
bgp always-compare-med
Commands
redistribute
414
Introduced on the C-Series.
Enter a number as the metric to be assigned to routes from
other protocols. The range is from 1 to 4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— enables comparison of all BGP MED attributes.
— redistributes routes from other routing protocols into BGP.
Border Gateway Protocol