Default-Metric - Dell S6000 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
To remove all configured debug commands for BGP, enter the no debug ip bgp
Information
command.

default-metric

Allows you to change the metric of redistributed routes to locally originated routes. Use this command
with the redistribute command.
S6000
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number
Defaults 0
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
358
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter a number as the metric to be assigned to routes from
other protocols. The range is from 1 to 4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Border Gateway Protocol