Resetting All Parameters; Reset All; Fls: Flash Setup (1) Res: Reset Config To Defaults - 3Com CoreBuilder 9000 User Manual

86 C 5: C
HAPTER ONFIGURING THE
Resetting All
Parameters

Reset All

P
LATFORM
You can reset all parameters for the CoreBuilder 9000 ATM Enterprise
Switch.
Reset all configuration parameters for the CoreBuilder 9000 ATM
Enterprise Switch to their factory default settings.
Some parameters are reset only after the next reboot. These parameters
include ATM addresses, PVC, IP parameters, and NMS parameters.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 2 1
The following message is displayed:
Reset of all saved configuration was done.
All configuration parameters are reset to their factory values.
(2) FLS: FLASH setup
(1) RES: Reset Config to Defaults
1 2 1
All configuration parameters are reset to their factory
default values.
Reset of all saved configuration was
done.