Update Vpi/Vci Range - 3Com CoreBuilder 9000 User Manual

186 C 7: C
HAPTER ONFIGURING
Update VPI/VCI
Range
V C
IRTUAL HANNELS
Update the VPI/VCI configuration parameters of the specified port. You
set maximum and minimum VPI/VCI values for each port. For more
information, see "Display VPI/VCI Range" on page 184.
Note that when the ILMI auto-configuration procedure is enabled, the
VPI/VCI limits are determined automatically and override any settings
made by this command. (For more information, see "Display Current IP
Configuration" on page 66).
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Port number
Parameter number
Direct access sequence:
Command Result
System action taken:
System message display:
(1) SET: Switch setup
(4) SIG: Signaling setup
(3) VCC: VPI/VCI range setup
(2) SET: Set VPI/VCI range
Format or Range
<slot.group.port> or 0.0 for all
1 for Min VPI
2 for Max VPI
3 for Min VCI
4 for Max VCI
1 1 4 3 2 [parameters]
Only one parameter can be defined per command.
The selected VPI/VCI configuration parameters are
updated for the specified port.
Parameter was successfully set.