Trace Subsystem; Copy Trace; Transfer Trace Data - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference

TRACe Subsystem

TRACe Subsystem
The TRACe subsystem controls access to the internal trace memory of
the analyzer.
Refer also to :CALCulate and :MMEMory subsystems for more trace and
NOTE
limit line commands.

Copy Trace

:TRACe:COPY <source_trace>,<dest_trace>
Transfers the source trace to the destination trace and leaves the
destination trace in VIEW mode.
Example:
Front Panel
Access:

Transfer Trace Data

:TRACe[:DATA] <trace_name>|RAWTRACE,<definite_length_
block>|<comma_separated_ASCII_data>
:TRACe[:DATA]? <trace_name> |RAWTRACE|LLINE1|LLINE2
This command transfers trace data from the controller to the
instrument. The data format is set by the command :FORMat
[:TRACe][:DATA]. The data is comma-separated ASCii values in ASCii
formatting, and a definite length block in REAL, INTeger, and
UINTeger formatting.
The query returns the current values of the designated trace. The data
is terminated with <NL><END> (for GPIB that is newline, or linefeed,
followed by EOI set true; for RS-232 this is newline only.)
LLINE1 and LLINE2 can only be queried; they cannot be set.
<trace_name> is TRACE1|2|3
5-136
Source traces are: TRACE1|2|3, LLINE1, LLINE2, and
RAWTRACE
Destination traces are: TRACE1|2|3, LLINE1, LLINE2, and
RAWTRACE
:TRAC:COPY TRACE2,TRACE1
View/Trace, Operations, 1 –> 3
View/Trace, Operations, 2 –> 3
Chapter 5