Programming Command Compatibility; Across Model Numbers And Across Modes; Across Psa Modes: Command Subsystem Similarities - Agilent Technologies PSA Series Manual

Front-Panel Key and SCPI Command Reference
Programming Command Compatibility Across Model Numbers and Across Modes

4.1 Programming Command Compatibility

Across Model Numbers and Across Modes

4.1.1 Across PSA Modes: Command Subsystem Similarities

When you select different modes you get different sets of available programming commands. That is, only the
commands that are appropriate for the current mode are available. Also, some commands have the same syntax
in different modes but have different ranges or settings that are only appropriate to the current mode.
The following table shows which command subsystems are the same across different modes. If there is no "X"
by a particular subsystem, then the set of available commands is different in those modes. Command ranges or
defaults may also be different. Refer to the programming command descriptions in the documentation for each
mode for details.
Command Subsystem
IEEE common commands
ABORt
CALCulate
CALibration
CONFigure
COUPle
DISPlay
FETCh
FORMat
HCOPy
INITiate
INPut
MEASure
MEMory
MMEMory
120
Same command set is available:
SA mode compared with the
application modes: Digital
Modulation, Basic, WLAN,
W-CDMA, cdmaOne, cdma2000,
1xEV-DO, GSM, EDGE, NADC,
PDC, or Measuring Receiver
X
X
X
not available in these application
modes
X
not available in these application
modes
X
X
Same command set is available:
SA mode compared with the
application modes: Phase Noise,
Noise Figure, TD-SCDMA
X
X
X
not available in these application
modes
X
X
X
X
X
Chapter 4