WireScope SmartProbes
WireScope probe configuration warnings
The WireScope 350 uses test probes called SmartProbes to connect to
the cabling runs that it certifies. All WireScope 350 test probes connect
to the SmartProbe port at the top of the WireScope and DualRemote. The
WireScope 350 automatically detects any SmartProbes connected to it,
and configures its interface to the matching parameters.
The WireScope 350 displays a warning when it detects a potential
conflict between the detected probe and any of the test settings. Using
an inappropriate probe can affect measurement accuracy. This is
especially important for category 6 installations.
If the WireScope detects an over-voltage condition at the SmartProbe
port, it displays the following warning message:
&DXWLRQ
Irr
ÃprpÃXv
rTprÃrÃ
irÃ
ÃrÃphiyrÃÃhÃyhtrÃ
prÃpuÃhÃ
ryrurÃwhpxÃ@prvrÃyhtrÃphÃqhhtrÃXv
rTprÃ
irÃhqÃurÃXv
rTprÃ
"$Ãhhyr
ÃhqÃvqÃ
Ãh
h
BrvtÃTh
rq
Xv
rTprÃTh
Q
ir
1−7