Before You Begin; Figure - Cisco ONS 15327 Procedure Manual

Connect the PC and Log into the GUI
This chapter explains how to connect PCs and workstations to the Cisco ONS 15327 and how to log into
Cisco Transport Controller (CTC) software, the Cisco ONS 15327 Operation, Administration,
Maintenance, and Provisioning (OAM&P) user interface.

Before You Begin

This section lists the chapter procedures (NTPs). Review the procedure for applicable tasks (DLPs).
1.
2.
3.
NTP-B21 Set Up Computer for CTC
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 If your computer is a Windows PC, complete the
Windows" task on page
Step 2 If your computer is a UNIX workstation, complete the
UNIX" task on page
Step 3 If your computer is a UNIX workstation and you installed the JRE in
Set Up the Java Runtime Environment for UNIX" task on page
March 2003
NTP-B21 Set Up Computer for CTC, page
has never been connected to an ONS 15327.
NTP-B22 Set Up CTC Computer to Connect to the ONS 15327, page
workstation is set up for CTC, complete this procedure to set up your computer to connect to the
ONS 15327.
NTP-B23 Log into the ONS 15327 GUI, page
This procedure explains how to configure your PC or UNIX workstation to
run Cisco Transport Controller (CTC).
Cisco ONS 15327 Release 4.0 software or documentation CD
Required
Onsite or remote
None
2-2, then go to
2-5.
C H A P T E R
2-1—Complete this procedure if your PC or workstation
2-22—Complete this procedure to log into CTC.
"DLP-B47 Run the CTC Installation Wizard for
Step 4.
"DLP-B48 Run the CTC Installation Wizard for
2-7.
Cisco ONS 15327 Procedure Guide, R4.0
2
2-8—After your PC or
Step 2, complete the "DLP-B49
2-1