Figure 6-7 Selecting The Edit Path Trace Option; Table 6-2 Path Trace Source And Drop Provisioning - Cisco ONS 15327 User Documentation

Chapter 6 Circuits and Tunnels
Table 6-2
Step
1
2
3
4
5
6
Procedure: Create a J1 Path Trace
To perform this procedure, you must have an STS circuit using the DS-1 ports on the XTC card at the
circuit source and drop ports, or an STS circuit passing through an OC-3 or OC-48 card.
Log into the circuit source node and select the Circuits tab.
Step 1
Select the circuit you want to trace, then click Edit.
Step 2
Step 3 On the Edit Circuit window, click Show Detailed Map at the bottom of the window.
On the detailed circuit map, right-click the source port for the circuit and select Edit Path Trace from
Step 4
the shortcut menu.
Figure 6-7
June 2002
Path Trace Source and Drop Provisioning
Port Action
Source Edit the path-trace transmit string. If not edited, an empty string is transmitted.
Drop Edit the path-trace transmit string. If not edited, an empty string is transmitted.
Source Edit the path-trace expected
string.
Drop Edit the path-trace expected string Only Path Trace mode is set to Manual, and only
Drop Change Path Trace Mode
Source Change Path Trace Mode
Figure 6-7 shows an example.
Selecting the Edit Path Trace option
Notes
Only if Path Trace mode is set to Manual, and only
on DS-1 ports.
on DS-1 ports.
Automatic or Manual.
Automatic or Manual.
Cisco ONS 15327 User Documentation, R3.3
Creating a Path Trace
6-13