Dlp-B233 Edit Path Protection Circuit Path Selectors - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 8
Manage Circuits
d.
Return to your originating procedure (NTP).
Step 7
DLP-B233 Edit Path Protection Circuit Path Selectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Circuits tab.
Step 1
Click the UPSR circuit(s) you want to edit. To change the settings for multiple circuits, press the Shift
Step 2
key (to choose adjoining circuits) or the Ctrl key (to choose non-adjoining circuits) and click each
circuit you want to change.
Step 3
From the Tools menu, choose Circuits > Set Path Selector Attributes.
Note
In the Path Selectors Attributes dialog box
Step 4
needed:
•
•
•
•
•
Click OK and verify that the changed values are correct.
Step 5
March 2003
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box displayed.
Use this task to change the path protection signal fail and signal degrade
thresholds, the reversion and reversion time, and the PDI-P settings for one
or more path protection circuits.
None
NTP-B44 Provision Path Protection Nodes, page 4-23
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Alternatively, for single circuits you can click the Edit button, then click the UPSR Selectors
tab on the Edit Circuits window.
Revertive—If checked, traffic reverts to the working path when conditions that diverted it to the
protect path are repaired. If the check box is not selected, traffic does not revert.
Reversion Time (Min)—If Revertive is checked, this value sets the amount of time that will elapse
before traffic reverts to the working path. The range is 0.5 to 12 minutes in 0.5 minute increments.
SF Ber Level—Sets the path protection signal failure BER threshold (STS circuits only).
SD Ber Level—Sets the path protection signal degrade BER threshold (STS circuits only).
PDI-P—When checked, traffic switches if an STS payload defect indication is received (STS
circuits only).
NTP-B151 Modify Circuit Characteristics
(Figure
8-2), edit the following path protection selectors, as
Cisco ONS 15327 Procedure Guide, R4.0
8-11
Advertisement
Table of Contents
