Log Into Fdm; Complete The Initial Configuration - Cisco Firepower 1010 Getting Started Manual

Firepower Threat Defense Deployment with CDO

Log Into FDM

Log into FDM to configure your FTD.
Before you begin
• Use a current version of Firefox, Chrome, Safari, Edge, or Internet Explorer.
Procedure
Step 1
Enter the following URL in your browser.
•
• Inside (Ethernet1/2 through 1/8)—https://192.168.1.1.You can connect to the inside address on any
• (6.6 and later) Management—https://management_ip. The Management interface is a DHCP client, so
• (6.5 and earlier) Management—https://192.168.45.45. If you changed the Management IP address at
Step 2 Log in with the username admin, and thedefault password Admin123.
What to do next
• Run through the FDM setup wizard; see

Complete the Initial Configuration

Use the setup wizard when you first log into FDM to complete the initial configuration. After you complete
the setup wizard, you should have a functioning device with a few basic policies in place:
• An outside (Ethernet1/1) and an inside interface. Ethernet1/2 through 1/8 are switch ports on the inside
• Security zones for the inside and outside interfaces.
• An access rule trusting all inside to outside traffic.
• An interface NAT rule that translates all inside to outside traffic to unique ports on the IP address of the
• A DHCP server running on the inside interface.
inside switch port (Ethernet1/2 through 1/8).
the IP address depends on your DHCP server. If you changed the Management IP address at the CLI
setup, then enter that address.
the CLI setup, then enter that address.
VLAN1 interface (6.5 and later) or inside bridge group members on BVI1 (6.4).
outside interface.
Complete the Initial Configuration, on page
Cisco Firepower 1010 Getting Started Guide
Log Into FDM
70.
35