Dlp-B114 View Conditions - Cisco ONS 15327 Procedure Manual

Chapter 6 Manage Alarms
At the card, node, or network view, click the Alarms tab.
Step 1
Click Synchronize.
Step 2
This button causes CTC to retrieve a current alarm summary for the card, node, or network. This step is
optional because CTC updates the Alarms window automatically as messages arrive from the node.
Alarms that have been raised during the session will have a check mark in the Alarms window New
column. When you click Synchronize, the check mark disappears.
Return to your originating procedure (NTP).
Step 3

DLP-B114 View Conditions

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the card, node, or network view, click the Conditions tab.
Step 1
Click Retrieve
Step 2
The Retrieve button requests the current set of fault conditions from the node, card, or network. The
window is not updated when conditions change on the node. You must click Retrieve to see any changes.
November 2004
Use this task to view conditions, [events with a Not-Reported (NR)
severity] at the card, node, or network level. Conditions give you a clear
record of changes or events that do not result in alarms.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve
(Figure 6-5).
NTP-B196 View Alarms, History, Events, and Conditions
Cisco ONS 15327 Procedure Guide, R4.0
6-11