Restoring The Database To A Previous Or Original Configuration; Node Is Functioning Improperly Or Has Incorrect Data; Figure 1-18 Dcn Tools Ospf Dump - Cisco ONS 15600 SDH Troubleshooting Manual

1.5 Restoring the Database to a Previous or Original Configuration

Figure 1-18
The dump, which provides the same information as a dump executed by special networking commands,
is available in the network view Maintenance > Diagnostic tab. You can select the access point node in
the Select Node drop-down list. To create the dump, click Retrieve. (To clear the dump, click Clear.)
The contents of this file can be saved or printed and furnished to Cisco Technical Support for use in
OSPF network support.
1.5 Restoring the Database to a Previous or Original
Configuration
This section contains troubleshooting for node operation errors that might require restoring software
data or restoring the node to the default setup.

1.5.1 Node is Functioning Improperly or Has Incorrect Data

Symptom
Table 1-1
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
1-50
DCN Tools OSPF Dump
One or more nodes are not functioning properly or have incorrect data.
describes the potential cause of the symptom and the solution.
Chapter 1 General Troubleshooting
July 2010