Ntp-H102 Back Up The Database - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
17.

NTP-H102 Back Up the Database

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You must back up and restore the database for each node on a circuit path in order to maintain a complete
Note
circuit.
The following parameters are not backed up and restored: node name, IP address, subnet mask and
Note
gateway, and Internet Inter-ORB Protocol (IIOP) port. If you change the node name and then restore a
backed up database with a different node name, the circuits map to the new node name. Cisco
recommends keeping a record of the old and new node names.
Complete the
Step 1
already logged in, continue with Step 2.
In node view, click the Maintenance > Database tabs.
Step 2
Click Backup.
Step 3
In the Backup Database window, click Browse.
Step 4
In the Save window, navigate to a local PC directory or network directory and type a database name (such
Step 5
as database.db) in the File name field.
Note
Click Save.
Step 6
Step 7 Click OK to confirm the path and file name.
Step 8 If you are overwriting an existing file, click OK in the confirmation dialog box.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
14-2
NTP-H139 Export Network Element Defaults, page
factory-configured (default) NE settings.
This procedure stores a backup version of the Cisco Transport
Controller (CTC) software database on the workstation running CTC or
on a network server.
None
None
Required. Cisco recommends performing a database backup at
approximately weekly intervals and prior to and after configuration
changes.
Onsite or remote
Maintenance or higher
"DLP-H29 Log into CTC" task on page 16-43
The database file must have a *.db extension.
Chapter 14
14-21—Complete as needed to export the
at the node you want to back up. If you are
Maintain the Node
78-19416-01