Table of Contents
Advertisement
Chapter 5
Setting Up Devices—CiscoWorks 1105/1130/1130-19
Step 7
Using the AP Web Interface for Network Management Set Up
Step 1
Step 2
78-16345-01
To enable and configure SSH, enter the following commands. In these
•
commands, hostname is the hostname of the access point, and domain_name
is your network's domain name (for example, cisco.com). At the prompt for
the number of bits in the modulus, press Return to accept the default or enter
a value.
hostname hostname
ip domain-name domain_name
crypto key generate rsa
How many bits in the modulus [512]:
The following commands are recommended, but optional:
ip ssh time-out 120
ip ssh authentication-retries 3
To configure Telnet, enter the following commands:
•
line 0 4
no access-class 111 in
The following commands are recommended, but optional:
width 80
length 24
Exit global configuration mode, then enter the following command:
write memory
To configure IOS devices by using the device Web interface:
Procedure
Log into the Web interface of the access point.
To enable CDP, select SERVICES from the menu, then click CDP:
After Cisco Discovery Protocol (CDP), select Enabled.
a.
Click Apply.
b.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Setting Up IOS Access Points
5-7
Advertisement
Table of Contents
