Subaru IMPREZA GD 2007 Series Manual page 3999

asieps_tobira_IM_US.book 16 ページ ２０１２年１月１７日 火曜日 午後３時４８分
LIGHTING SYSTEM
6) Disconnect the connector from the headlight bal-
last.
CAUTION:
Be careful as the claw is easily broken.
7) Turn the level adjustment screw so that the
beam is pointed upwards, and make space so that
the socket can pass through the inside of the lamp.
CAUTION:
Make sure that the reflector does not interfere
with the extension case.
8) Insert the socket towards the front of the reflec-
tor bracket.
9) Turn the level adjustment screw so that the
beam is pointed downward, and make space so
that the socket can pass through the lower side of
the reflector bracket.
CAUTION:
Make sure that the reflector does not interfere
with the extension case.
10) From the lower side of the housing, pull the
socket out of the headlight.
CAUTION:
Do not get the socket caught between the re-
flector and light housing.
D: ASSEMBLY
1. HID HEADLIGHT BALLAST
Assemble in the reverse order of disassembly.
Headlight Assembly
E: ADJUSTMENT
1. HEADLIGHT BEAM ADJUSTMENT
CAUTION:
Turn off the light before adjusting the headlight
beam level. If the light is necessary to check
aiming, do not illuminate for two minutes or
more.
NOTE:
Before checking the headlight beam level, be sure
of the following:
• The area around the headlight has not sustained
LI-00481
any accident, damage or other type of deformation.
• Vehicle is parked on level ground.
• The inflation pressure of tires is correct.
• Vehicle's fuel tank is fully filled.
1) Bounce the vehicle several times to normalize
the suspension.
2) Make certain that someone is seated in the driv-
er's seat.
3) Measure the distance between the low beam
bulb centers, and the height of the bulb center.
4) Light the headlights, and adjust the low beam
while projecting onto a screen.
• HALOGEN TYPE
(A) Vertical direction
(B) Horizontal direction
• HID TYPE
(A) Vertical direction
(B) Horizontal direction
LI-16
(B)
(A)
LI-00586
(B)
(A)
LI-00592