Subaru IMPREZA GD 2007 Series Manual page 3998

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
12.Headlight Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the duct (when right side headlight is
removed).
3) Remove the front bumper. <Ref. to EI-24, RE-
MOVAL, Front Bumper.>
4) Disconnect harness connectors.
5) Remove the headlight assembly side section
bolts.
6) Remove the 3 bolts, disengage the clip, then de-
tach the headlight assembly.
B: INSTALLATION
Install in the reverse order of removal.
Headlight Assembly
C: DISASSEMBLY
1. HID HEADLIGHT BALLAST
CAUTION:
• Do not operate with wet hands.
• As the HID headlight uses high voltages in
the lighting circuit, be sure to confirm that the
power supply is turned off before operation.
(A)
• Do not leave the headlight without a ballast
for long periods of time. Dust, moisture, etc. en-
tering the headlight may affect its performance.
1) Disconnect the ground cable from the battery.
2) Remove the headlight assembly. <Ref. to LI-15,
REMOVAL, Headlight Assembly.>
3) Remove the back cover.
LI-00190
4) Disconnect the harness connector.
LI-00565
5) Loosen the screw and remove the ballast body.
LI-00551
LI-15
LIGHTING SYSTEM
LI-00611
LI-00479
LI-00480