Cruise Control Command Switch - Subaru Legacy 2005 Service Manual

3. Cruise Control Command
Switch
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the "AB" section for proper handling of the
driver's airbag module. <Ref. to AB-5, CAU-
TION, General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using TORX BIT T30 (Tamper resistant type),
®
loosen the two TORX
airbag module.
(1) TORX ®
BIT T30
5) Disconnect the airbag module connector on
back of the airbag module. <Ref. to AB-11, PRO-
CEDURE, Airbag Connector.>
6) Remove the steering wheel. <Ref. to PS-21, RE-
MOVAL, Steering Wheel.>
7) Remove the four screws to remove the lower
cover from steering wheel.

Cruise Control Command Switch

bolts which secure driver's
(1)
CC-00018
CC-00181
8) Remove one screw to remove the cruise control
command switch from lower cover.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the cruise control command switch resis-
tance.
Switch Area
CANCEL
SET/COAST ALL
RESUME/ OFF
ACCEL
CANCEL ON
SET/COAST ON
RESUME/
ON
ACCEL
OFF
MAIN
ON
If NG, replace the cruise control command switch.
CC-5
CRUISE CONTROL SYSTEM
CC-00182
1 2 3
CC-00252
Terminal No. Standard
2 and 3 Approx. 4 kΩ
Less than 1 Ω
2 and 3
Approx. 250 Ω
2 and 3
Approx. 1500 Ω
2 and 3
1 and 2 More than 1 MΩ
Less than 1 Ω
1 and 2