Subaru IMPREZA GD 2007 Series Manual page 4141

asieps_tobira_IM_US.book 45 ページ ２０１２年１月１７日 火曜日 午後３時４８分
20.Ignition Key Lock
A: REPLACEMENT
1) Disconnect the ground cable from the battery.
2) Remove the steering column. <Ref. to PS-21,
REMOVAL, Tilt Steering Column.>
3) Secure the steering column in a vise. Remove
the bolt with a drill.
4) Remove the ignition key lock.
5) Use a new tone bolt. Tighten the tone bolt all the
way.
B: INSPECTION
1) Remove the instrument panel lower cover.
2) Remove the lower column cover.
3) Unfasten the fixing clip which secures harness,
and then disconnect the connector of the ignition
switch from body harness.
4) Turn the ignition key plate to each position and
check the continuity between terminals of ignition
connector.
Switch position Terminal No.
LOCK
ACC No. 1 and No. 2
No. 1 and No. 2
ON No. 1 and No. 4
No. 2 and No. 4
No. 1 and No. 3
ST No. 1 and No. 4
No. 3 and No. 4
If NG, replace the ignition switch.
Ignition Key Lock
SL-00024
SL-00025
Standard
— —
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
SL-45
SECURITY AND LOCKS