Cruise Control Command Switch - Subaru Impreza 2002 Service Manual

CRUISE CONTROL SYSTEM
5. Cruise Control Command
Switch
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the AB section for proper handling of the driv-
er's airbag module. <Ref. to AB-3, CAUTION,
General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using the TORX
type), loosen the two TORX
driver's airbag module.
5) Disconnect the airbag module connector on
back of airbag module.
6) Remove the horn switch from steering wheel as
shown.

CRUISE CONTROL COMMAND SWITCH

BIT T30 (Tamper resistant
®
bolts which secure
H5M0662A
S6M0095
7) Disconnect the horn and cruise control com-
mand switch connector, then remove the cruise
control command switch.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the cruise control command switch resis-
tance.
Switch Position
ON
CANCEL
ON
OFF
SET/COAST
ON
OFF
RESUME/
ACCEL
ON
If NG, replace the cruise control command switch.
CC-6
S6M0096
B6M1406
Terminal No. Standard
Less than 1 Ω
1 (+) and 2 (−)
Less than 1 Ω
1 (+) and 3 (−)
More than 1 M Ω
1 and 2
Less than 1 Ω
1 and 2
More than 1 M Ω
1 and 3
Less than 1 Ω
1 and 3