Subaru IMPREZA GD 2007 Series Manual page 4119

asieps_tobira_IM_US.book 23 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Step
8 CHECK BATTERY OPEN CIRCUIT PROTEC-
TION FEATURE.
Check that the system functions properly even
if the battery is not connected temporally. <Ref.
to SL-23, CHECK BATTERY OPEN CIRCUIT
PROTECTION FEATURE, INSPECTION,
Security System.>
9 CHECK IMPACT SENSOR.
Check the sensitivity of impact sensor. <Ref. to
SL-53, CHECK IMPACT SENSOR, ADJUST-
MENT, Impact Sensor.>
2. CHECK BATTERY OPEN CIRCUIT
PROTECTION FEATURE
1) Remove the key from ignition switch.
2) Open the front hood.
3) Close all the doors and the rear gate.
4) Press the LOCK/ARM button of the transmitter.
5) Disconnect the ground cable from the battery.
6) Connect the ground cable to the battery.
7) After connecting the battery negative terminal,
check whether or not the security indicator light
flashes.
If it does not flash, replace the keyless entry control
module.
3. SECURITY SYSTEM ON/OFF SETTING
1) Close all doors, trunk lid and rear gate, and sit
down on the driver seat. Press the UNLOCK button
of the keyless transmitter.
2) Turn the ignition switch to ON.
3) At the same time as pushing the UNLOCK side
of the central door lock switch, open the driver's
side door, and maintain this condition for 10 sec-
onds.
4) The security system setting is switched (ON
←→ OFF) and the horn sounds.
Setting
OFF → ON
ON → OFF
NOTE:
For information on setting ON/OFF of the security
system through the Subaru Select Monitor, refer to
the following:<Ref. to SL-49, PROCEDURE, Secu-
rity Control Unit.>
Security System
Does the system function prop-
erly when the battery is not con-
nected temporarily?
Is the sensibility set properly?
Notice
The horn sounds once.
The horn sounds twice.
SL-23
SECURITY AND LOCKS
Check Yes
Go to step 9.
Press the
UNLOCK/DIS-
ARM button of the
transmitter, and
finish the diagno-
sis.
No
Replace the key-
less control mod-
ule.
Adjust the sensibil-
ity. <Ref. to SL-53,
IMPACT SENSI-
TIVITY ADJUST-
MENT,
ADJUSTMENT,
Impact Sensor.>