Subaru IMPREZA GD 2007 Series Manual page 4149

asieps_tobira_IM_US.book 53 ページ ２０１２年１月１７日 火曜日 午後３時４８分
27.Impact Sensor
A: REMOVAL
1) Remove the key from ignition switch.
2) Close all the doors, trunk lid and rear gate.
3) Press the UNLOCK button of the keyless trans-
mitter.
4) Change the setting of impact sensor using Sub-
aru Select Monitor.
5) Disconnect the ground cable from the battery.
6) Remove the impact sensor.
B: INSTALLATION
1) Remove the key from ignition switch.
2) Close all the doors, trunk lid and rear gate.
3) Press the UNLOCK button of the keyless trans-
mitter.
4) Disconnect the ground cable from the battery.
5) Install the impact sensor.
6) Connect the ground cable to the battery.
7) Change the setting of impact sensor using Sub-
aru Select Monitor.
C: OPERATION
1. IMPACT SENSOR SETTING USING SUB-
ARU SELECT MONITOR
1) Connect the Subaru Select Monitor to the data
link connector.
2) Turn the ignition switch to ON.
3) Select {keyless unit} from the main menu.
4) Select {ECM customizing}.
5) Make a impact monitor setting.
• When installing: ON
• When removing: OFF
6) Make a impact monitor ON/OFF setting.
• When installing: ON
• When removing: OFF
7) Turn the ignition switch to OFF, and stop the
Subaru Select Monitor.
Impact Sensor
D: ADJUSTMENT
1. CHECK IMPACT SENSOR
1) Remove the key from ignition switch.
2) Close all the windows.
3) Close all the doors, trunk lid and rear gate.
Leave open the front hood.
4) Press the LOCK button of the keyless transmit-
ter from outside of vehicle.
5) Check that the security indicator light blinks
twice within 0.5 seconds in 2 second cycles after 30
seconds.
6) Hit the windshield with the palm of your hand re-
peatedly with force and check that the security
alarm operates. Lift up the front hood approx. 12
cm (4.7 in) or more, and then drop it off to check the
operation of security alarm.
7) If NG, adjust the impact sensitivity.
2. IMPACT SENSITIVITY ADJUSTMENT
1) Connect the Subaru Select Monitor to the data
link connector.
2) Turn the ignition switch to ON.
3) Select {Impact Sensor} from the main menu.
4) Make a {Sensitivity Adjustment Mode}.
• Sensitivity can be adjusted in 11 levels (0 to 10).
• Initial setting is 5.
• Smaller number means more sensitive.
• Larger number means less sensitive.
5) Turn the ignition switch to OFF, and stop the
Subaru Select Monitor.
NOTE:
• Set the sensor so as not to let the alarm on nor-
mal vibration (reclining to the door, hit the ball and
etc.).
• Set the sensor to operate the alarm with hitting
the door or window glass, etc. continuously like a
mayhem by robbery.
• Ask the customer about parking situation for set-
ting, because the alarm operate when the vibration
not only the burglar but also the construction etc.
SL-53
SECURITY AND LOCKS