Subaru IMPREZA GD 2007 Series Manual page 4038

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
When malfunction of the airbag system and the occupant detection system occur, the DTC stored in airbag
control module will be read out.
Refer to the DTC readout of the airbag system (diagnosis). <Ref. to AB(diag)-28, OPERATION, Subaru Se-
lect Monitor.>
NOTE:
• For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
• For details concerning DTCs, refer to the "List of Diagnostic Trouble Code (Airbag system, Occupant de-
tection system)". <Ref. to AB(diag)-43, List of Diagnostic Trouble Code (DTC).> <Ref. to OD(diag)-25, List of
Diagnostic Trouble Code (DTC).>
2. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch and
seat position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.
1) On the «Main Menu» display screen, select {Each System Check}.
2) On the «System Selection Menu» display screen, select {Airbag System}.
3) On the «Airbag System» menu screen, select {Status Data}.
Support data is listed in the following table.
Contents
Seat position sensor LH
Seat position sensor RH
Seat belt buckle switch LH
Seat belt buckle switch RH
Passenger's airbag control status
*1: The seat position is forward.
*2: The seat position is rearward.
*3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input.
*4: Displayed when it is initial.
*5: Seat position sensor not supported
*6: Seat belt fastened
*7: Seat belt not fastened
*8: Displayed when data other than belt fastened or not fastened, such as breakdowns is input.
*9: Seat belt buckle switch not supported
*10: Passenger's airbag operating state
*11: Passenger's airbag non-operating state
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
3. CLEAR MEMORY MODE
Clear the DTC stored in the airbag control module
after repairing the airbag system and occupant de-
tection system. (After the breakdown is recovered,
the breakdown code for completed recoveries are
read out when the next breakdown occurs if the
memory clear work is not performed.)
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Airbag System}.
Subaru Select Monitor
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS)
Content of diagnosis
*1
Front position /Rear position
*5
—
*6 *7 *8
Belted /Unbelted /Other
*6 *7 *8
Belted /Unbelted /Other
*10 *11
ON /OFF /Initial Setting
3) On the {Airbag System} display screen, select
{Clear Memory}.
4) When the "Clear Memory?" is shown on the
screen, select [OK].
5) When "Done" is shown on the display screen,
turn the ignition switch to OFF, and the Subaru Se-
lect Monitor switch to OFF.
NOTE:
For details concerning the operation procedure, re-
fer to the "SUBARU SELECT MONITOR OPERA-
TION MANUAL".
OD(diag)-17
*2 *3 *3 *5
/Other /Initial Setting / —
*4 *9
/Initial Setting / —
*4 *9
/Initial Setting / —
*4