CRUISE CONTROL SYSTEM
5. Cruise Control Command
Switch
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the AB section for proper handling of the driv-
er's airbag module. <Ref. to AB-3, CAUTION,
General Description.>
1. FOUR SPOKES STEERING WHEEL
MODEL
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using the TORX
type), loosen the two TORX
driver's airbag module.
5) Disconnect the airbag module connector on
back of airbag module.
6) Remove the horn switch from steering wheel as
shown.
CRUISE CONTROL COMMAND SWITCH
BIT T30 (Tamper resistant
®
bolts which secure
R
TORX BIT T30
CC-00018
CC-00019
7) Disconnect the horn and cruise control com-
mand switch connector, then remove the cruise
control command switch.
2. THREE SPOKES STEERING WHEEL
MODEL
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
4) Using the TORX
type), loosen the two TORX
driver's airbag module.
5) Disconnect the airbag module connector on
back of airbag module.
6) Remove the horn switch from steering wheel.
7) Remove the steering wheel. <Ref. to PS-23, RE-
MOVAL, Steering Wheel.>
8) Remove four screws, and then remove the lower
cover from steering wheel.
CC-6
CC-00020
®
BIT T30 (Tamper resistant
®
bolts which secure
R
TORX BIT T30
CC-00018
CC-00181