Subaru IMPREZA GD 2007 Series Manual page 4074

asieps_tobira_IM_US.book 10 ページ ２０１２年１月１７日 火曜日 午後３時４８分
SEAT BELT SYSTEM
5. Front Seat Belt
A: REMOVAL
1. OUTER SEAT BELT ASSEMBLY
1) Turn the ignition switch to OFF, disconnect the
battery ground cable, and wait for 20 seconds or
more.
2) Fold the backrest all the way forward, and then
move the front seat all the way forward.
3) Remove the center pillar lower trim. <Ref. to EI-
51, REMOVAL, Lower Inner Trim.>
4) Remove the anchor cover. Loosen the shoulder
anchor bolt, and then detach the shoulder anchor
from center pillar.
5) Turn over the floor mat to disconnect the con-
nector of belt tension sensor. (Passenger's side)
6) Turn over the floor mat to disconnect the con-
nector (A) of pretensioner, and then loosen the
three bolts to remove the outer seat belt assembly.
7) Remove the center pillar upper trim. <Ref. to EI-
50, REMOVAL, Upper Inner Trim.>
Front Seat Belt
8) Remove the two bolts to remove the adjustable
anchor assembly.
CAUTION:
• Do not drop or subject the pretensioner to
any impact.
• Since the pretensioner and bracket are inte-
grated as a unit, do not disassemble them.
2. INNER SEAT BELT ASSEMBLY
1) Turn the ignition switch to OFF, disconnect the
battery ground cable, and wait for 20 seconds or
more.
2) Remove the console box. <Ref. to EI-46, RE-
MOVAL, Console Box.>
SB-00003
3) Disconnect the seat belt warning light connector
under the seat.
4) Remove the harness clips from slide rail.
5) Remove the anchor bolt, and then detach the in-
ner belt assembly.
SB-00324
(A)
SB-00134
SB-10
SB-00117
SB-00006