Subaru IMPREZA GD 2007 Series Manual page 4087

asieps_tobira_IM_US.book 7 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2. Front Seat
A: REMOVAL
1) Disconnect the ground cable from the battery.
CAUTION:
The airbag system is fitted with a backup power
source. After disconnecting the battery ground
cable, the airbag may deploy if you do not wait
for 20 seconds before starting the service of
airbag system.
2) While pressing the headrest lock button, remove
the headrest.
3) Tilt the backrest forward.
4) Move the seat to full front end.
5) Remove the bolt cover at rear end of the slide
rail.
6) Remove the two bolts at rear end of slide rail.
7) Move the seat to full rear end.
Front Seat
8) Remove the two bolts at front side of slide rail.
9) Disconnect the connector under the seat.
• Seat position sensor connector (driver's seat)
• Seat belt buckle switch connector (driver's seat)
• Harness connector of occupant detection control
module (passenger's seat)
• Side airbag connector
• Seat heater connector (model with seat heater)
SE-00003
SE-00048
(1) Driver's seat
(2) Passenger's seat
10) Remove the front seat from vehicle.
SE-00049
SE-7
SEATS
SE-00006
(1)
(2)
SE-00657