Subaru IMPREZA GD 2007 Series Manual page 4177

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Front Wiper Motor and Link
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the cowl panel. <Ref. to EI-34, RE-
MOVAL, Cowl Panel.>
3) Disconnect the connector of motor.
4) Remove the bolts and remove the wiper link.
5) Remove the bolts and nuts, and then remove the
motor.
B: INSTALLATION
1) Connect the ground cable to the battery.
2) To confirm that the motor is at the auto stop po-
sition, connect the harness to the motor and turn
the wiper switch to ON/OFF once.
3) Disconnect the ground cable from the battery.
4) Tighten the nut where rod (A) and link plate (B) is
aligned in a straight line.
(A) (A) (B)
Front Wiper Motor and Link
5) Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to WW-2, FRONT WIPER, COMPO-
NENT, General Description.>
C: INSPECTION
1) When the battery is connected to the terminal of
connectors as shown in the figure, confirm that the
motor operates at low speed.
WW-00150
2) When the battery is connected to the terminal of
connectors as shown in the figure, confirm that the
wiper motor operates at high speed.
WW-00157
3) Connect the battery to terminals of the connec-
tor, and remove the terminal connection with motor
rotating at low speed, and stop the wiper motor in
mid-operation.
WW-00153
WW-13
WIPER AND WASHER SYSTEMS
3 2 1
5 4
WW-00457
3 2 1
5 4
WW-00458
3 2 1
5 4
WW-00459