Subaru IMPREZA GD 2007 Series Manual page 4059

asieps_tobira_IM_US.book 6 ページ ２０１２年１月１７日 火曜日 午後３時４８分
OPTION PARTS
3. Crossbar
A: REMOVAL
®
1) Remove TORX bolt T30 from each end sup-
port.
2) Turn the lower clamp of each end support 90°
downwards to remove the crossbar.
(1)
(2)
(3)
®
(1) TORX bolt T30
(2) End support
(3) Roof rail
(4) Lower clamp
CAUTION:
Be careful not to damage the roof panel during
removal and installation.
B: INSTALLATION
1) Turn the lower clamp of each end support ap-
prox. 90° downwards.
2) Set the front crossbar with the front direction
mark facing in the direction of vehicle front (the
front direction mark is on the top right side of the
crossbar).
3) Place the crossbar end support in the position
76.2 mm (3 in) behind the joint of front roof rail sup-
port and roof rail.
Length A:
76.2 mm (3 in)
(3)
A
(1) Front of vehicle
(2) Front direction mark
(3) Caution label (front crossbar)
Crossbar
(4)
OP-00007
(2)
(1)
OP-00008
OP-6
4) Set the rear crossbar with the front direction
mark facing in the direction of vehicle front. (the
front direction mark is on the top right side of the
crossbar).
5) Place the crossbar end support at the joint of
rear roof rail support and roof rail.
(2)
0
(1) Front of vehicle
(2) Front identification mark
6) Tighten the end support and clamp using
®
TORX bolt T30.
(1)
OP-00009