Subaru IMPREZA GD 2007 Series Manual page 4131

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Rear Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
11.Rear Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear door trim. <Ref. to EI-42, RE-
MOVAL, Rear Door Trim.>
3) Remove the sealing cover. <Ref. to EB-20, RE-
MOVAL, Rear Sealing Cover.>
4) Remove the rear inner remote. <Ref. to SL-33,
REMOVAL, Rear Inner Remote.>
5) Remove the three screws and one bolt.
SL-00183
6) Disconnect the connectors, and then remove the
rear door latch and door lock actuator assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works properly after installation.
C: INSPECTION
1) Make sure the rod is not deformed.
2) Make sure that the outer handle, rear remote
handle and rod move smoothly.
SL-35