Subaru IMPREZA GD 2007 Series Manual page 4086

asieps_tobira_IM_US.book 6 ページ ２０１２年１月１７日 火曜日 午後３時４８分
SEATS
B: CAUTION
• If the seat cushion cover is removed or replaced,
make sure to perform passenger detection system
adjustment after installing the seat to the vehicle.
<Ref. to OD(diag)-18, SYSTEM CALIBRATION
(REZEROING), OPERATION, Subaru Select Mon-
itor.>
Failure to do so may cause improper operation of
the occupant detection system.
• The passenger detection system (passenger
seat only) control unit and the passenger detection
sensor are fixed to the seat cushion frame. Never
remove the passenger detection control unit or the
pressure sensor from the seat cushion frame.
• Do not replace the seat cushion pad by itself. Al-
ways replace the seat cushion pad and frame as-
sembly as a set. The seat cushion pad and cushion
frame are adjusted as a set at the time of manufac-
ture. If cushion pads and cushion frames are com-
bined from those of other vehicles or other sets, the
passenger detection system may not operate prop-
erly.
• If the seat cushion cover is removed, make sure
to replace the wire on the seat cushion side with a
new wire. (Passenger's seat)
• Do not remove the seat position sensor from the
slide rail. (Driver's seat)
• When removing the front seat, follow cautions
given in the airbag section. <Ref. to AB-3, CAU-
TION, General Description.>
C: PREPARATION TOOL
1. GENERAL TOOL
TOOL NAME
Long nose plier
Hog ring pliers
General Description
Used for removing the hog ring.
Used for installing the hog ring.
SE-6
REMARKS