Subaru IMPREZA GD 2007 Series Manual page 4118

asieps_tobira_IM_US.book 22 ページ ２０１２年１月１７日 火曜日 午後３時４８分
SECURITY AND LOCKS
C: INSPECTION
1. BASIC DIAGNOSTIC PROCEDURE
NOTE:
• Turbo models are equipped with an immobilizer.
• Non-turbo models are not equipped with immobilizers.
Step
1 SECURITY SYSTEM SETTINGS.
Turn the security system setting to ON. <Ref. to
SL-24, SYMPTOM CHART, INSPECTION,
Security System.>
2 CHECK SECURITY SYSTEM SETTING OP-
ERATION.
1) Before starting this check, open all doors.
2) Pull out the key from the ignition key cylin-
der, and close all doors and the rear gate.
3) Press the LOCK/ARM button of the trans-
mitter.
3 CHECK SECURITY INDICATOR AND HAZ-
ARD LIGHT FLASHING CONDITION.
Check the security indicator and hazard light
flashing condition.
NOTE:
Models with the immobilizer will flash twice, and
those without will flash once.
4 CHECK SECURITY SYSTEM OPERATION.
Press the LOCK button of keyless transmitter,
and wait for 30 seconds.
5 CHECK SECURITY ALARM OPERATION.
1) Unlock all doors using the door lock switch
on the front door.
2) Open any door or rear gate.
6 CHECK SECURITY ALARM OPERATION.
Check the security alarm operation.
7 CHECK SECURITY ALARM CANCEL OPER-
ATION.
Press the UNLOCK/DISARM button of the key-
less transmitter.
NOTE:
Models with the immobilizer will flash once, and
those without will remain unlit.
Security System
Check
Is the setting process com-
pleted correctly?
Can the security system be
set?
Does the security indicator and
hazard light flash?
Does the security indicator light
flash twice within 0.5 seconds
in two second intervals?
Does the security alarm oper-
ate when opening any door or
rear gate?
Do all security alarms (horn,
hazard light and security indica-
tor light) operate, and the
starter motor stop operation?
Do all security alarms (horn
and hazard light) stop opera-
tion, and does the starter motor
operate?
SL-22
Yes No
Go to step 2. • Check the igni-
tion switch circuit.
<Ref. to SL-28,
CHECK IGNITION
SWITCH CIRCUIT,
INSPECTION,
Security System.>
• Check the door
lock switch circuit.
<Ref. to SL-9,
CHECK DOOR
LOCK SWITCH
AND CIRCUIT,
INSPECTION,
Door Lock Control
System.>
Go to step 3.
Go to symptom 1.
<Ref. to SL-24,
SYMPTOM
CHART, INSPEC-
TION, Security
System.>
Go to step 4.
Go to symptom 2.
<Ref. to SL-24,
SYMPTOM
CHART, INSPEC-
TION, Security
System.>
Go to step 5. Replace the key-
less control mod-
ule.
Go to step 6.
Go to symptom 3.
<Ref. to SL-24,
SYMPTOM
CHART, INSPEC-
TION, Security
System.>
Go to step 7. Go to symptom 4.
<Ref. to SL-24,
SYMPTOM
CHART, INSPEC-
TION, Security
System.>
Go to step 8.
Go to symptom 5.
<Ref. to SL-24,
SYMPTOM
CHART, INSPEC-
TION, Security
System.>