Subaru IMPREZA GD 2007 Series Manual page 3944

asieps_tobira_IM_US.book 3 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2. General Description
A: CAUTION
CAUTION:
• The airbag system wiring harness is routed
near the immobilizer control module.
• Do not use the electrical test equipment on
the airbag system wiring harnesses and con-
nector circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the immobilizer
control module.
• While diagnostic items are being checked, do
not operate radios, portable telephones, etc.
which emit electromagnetic waves near or in-
side the vehicle.
NG
• When the ignition switch is being turned ON
or OFF while diagnostic items are being
checked, do not allow keys with different ID
codes be close to the ignition switch. If the ig-
nition key is on a key holder, remove it from the
key holder before performing diagnoses.
NG
General Description
• When repeatedly turning the ignition switch
to ON or OFF while diagnostic items are being
checked, it should be switched in cycles of
"ON" for at least 5 seconds → "OFF" for at least
8 seconds.
(1) Ignition switch position
(2) Sec.
• If the engine fails to start with a registered ig-
nition key, detach the ignition key from ignition
switch and wait for approx. 1 second until secu-
rity indicator light begins to flash. And then
start the engine again.
• Before performing diagnostics, obtain all
keys and security IDs for the vehicle from the
owner.
IM-00211
IM-00212
IM(diag)-3
IMMOBILIZER (DIAGNOSTICS)
ON
(1)
OFF
5 8 (2)
IM-00003