Rear Combination Light Assembly - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 26 ページ ２０１２年１月１７日 火曜日 午後３時４８分
LIGHTING SYSTEM
19.Rear Combination Light
Assembly
A: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from the battery.
2) Remove the clips, and then remove the trunk
rear trim.
3) Remove the trunk side trim of rear portion.
4) Remove the four nuts, and then detach the rear
combination light after disconnecting the connec-
tor.
2. WAGON MODEL
1) Disconnect the ground cable from the battery.
2) Remove the clips and detach the rear combina-
tion light covers.

Rear Combination Light Assembly

3) Remove two bolts, and then remove the rear
combination light by pulling it backward.
4) Disconnect the harness connector and remove
the rear combination light.
LI-00208
B: INSTALLATION
1. SEDAN MODEL
Install in the reverse order of removal.
2. WAGON MODEL
Install in the reverse order of removal.
NOTE:
LI-00209
Install the rear combination light by aligning the clip
with body side.
LI-00210
LI-26
LI-00211
LI-00760
LI-00569