Subaru IMPREZA GD 2007 Series Manual page 4092

asieps_tobira_IM_US.book 12 ページ ２０１２年１月１７日 火曜日 午後３時４８分
SEATS
8) Remove the hooks (A), and then remove the
seat cushion frame assembly.
9) Remove the bolt of the sliding adjustment bar
and connecting wire.
10) Remove the bolts, then remove the slide rail.
Front Seat
(A)
SE-00338
SE-00340
SE-00409
SE-12
D: ASSEMBLY
CAUTION:
1. When the backrest cover is not installed se-
curely, the side airbag module may not be de-
ployed properly, therefore keep strictly to the
following procedure.
• Be careful not to stain or damage the back-
rest cover during assembly.
• Always use new hog rings.
• Secure the hog ring using hog ring pliers.
• Install the hog rings to the specified points
securely and make sure that no wrinkle or
twisting on backrest cover.
2. Make sure to adhere to the following rules
when assembling the passenger seat. Improper
work procedures can cause the passenger de-
tection system to not operate properly.
• If the seat cushion cover is removed or re-
placed, make sure to perform passenger de-
tection system adjustment after installing the
seat to the vehicle. <Ref. to OD(diag)-18, SYS-
TEM CALIBRATION (REZEROING), OPERA-
TION, Subaru Select Monitor.>
• Failure to do so may cause improper acti-
vation of passenger's airbag.
• The passenger detection system (passen-
ger seat only) control unit, passenger detec-
tion sensor, seat cushion pad and seat
cushion frame are considered as a single
seat cushion pad and frame assembly. Never
remove the passenger detection control unit
or the pressure sensor from the seat cushion
frame.
• Do not remove the seat position sensor
from the seat rail. (Driver's seat)
• If the seat cushion cover is removed, make
sure to replace the wire on the seat cushion
side with a new wire. (Passenger's seat)
• Make sure to install the hog rings/clips to
the specified locations. Do not reuse hog
rings.
Assemble in the reverse order of disassembly.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-2, FRONT SEAT, COMPO-
NENT, General Description.>