Subaru IMPREZA GD 2007 Series Manual page 3985

asieps_tobira_IM_US.book 2 ページ ２０１２年１月１７日 火曜日 午後３時４８分
LIGHTING SYSTEM
1. General Description
A: SPECIFICATION
Headlight
Front turn signal light
Clearance / Parking / Front side marker light
Front fog light
Rear combination light
License plate light
High-mounted stop light
Room light
Spot map light
Luggage room light
Trunk room light
Glove box light
B: CAUTION
• Before removing or installing parts, always disconnect the battery ground cable from battery. When replac-
ing the radio, control unit, and other parts provided with memory functions, record the memory contents be-
fore disconnecting the battery ground cable. Otherwise, the memory is cleared.
• Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.
• Adjust parts to the given specifications.
• Connect the connectors and hoses securely during reassembly.
• After reassembly, make sure functional parts operate smoothly.
WARNING:
• The airbag system wiring harness is routed near electrical parts and switches.
• Do not use the electrical test equipment on the airbag system wiring harnesses and connector cir-
cuits.
• Be careful not to damage the airbag system wiring harness when servicing electrical parts and
switches.
C: PREPARATION TOOL
1. GENERAL TOOL
Circuit tester
General Description
Halogen type low beam
HID type low beam
High beam
Tail / Rear side marker / Stop light
Sedan Tail light
Stop light
Wagon Tail / Rear side marker / Stop light
Turn signal light
Back-up light
Standard type
Sedan
Rear spoiler built-in type
Wagon
TOOL NAME
LI-2
12 V — 55 W
D2S 35W
12 V — 60 W
12 V — 21 W (WY21W)
12 V — 5 W
12 V — 55 W
12 V — 5/21 W
12 V — 5/21 W
12 V — 21 W
12 V — 5/21 W
12 V — 21 W (WY21W)
12 V — 21 W
12 V — 5 W
12 V — 21 W
12 V — 1.2 W (LED)
12 V — 13 W
12 V — 8 W
12 V — 8 W
12 V — 5 W
12 V — 5 W
12 V — 1.4 W
REMARKS
Used for measuring resistance and voltage.