Cruise Control Command Switch - Subaru Legacy 2002 Service Manual

Cruise Control System
5. Cruise Control Command
Switch
S912497
A: REMOVAL
S912497A18
WARNING:
Before servicing, be sure to read the notes in
the AB section for proper handling of the driv-
er's airbag module. <Ref. to AB-3, CAUTION,
General Description.>
1) Set front wheels in straight ahead position.
2) Turn ignition switch OFF.
3) Disconnect ground cable from battery and wait
for at least 20 seconds before starting work.
4) Using TORX BIT T30 (Tamper resistant type),
loosen two TORX bolts which secure driver's air-
bag module.
5) Disconnect airbag module connector on back of
airbag module.
6) Remove horn switch from steering wheel as
shown.

CRUISE CONTROL COMMAND SWITCH

H5M0662A
S6M0095
7) Disconnect horn and cruise control command
switch connector, then remove cruise control com-
mand switch.
B: INSTALLATION
Install is in the reverse order of removal.
C: INSPECTION
Measure cruise control command switch resis-
tance.
Check continuity between cruise control command
switch terminals.
Switch Position
CANCEL
SET/COAST
RESUME/
ACCEL
If NG, replace cruise control command switch.
CC-8
S912497A11
S912497A10
Terminal No.
1 (+) and Less than
ON
2 (−)
1 (+) and Less than
ON
3 (−)
More than
OFF 1 and 2
Less than
ON 1 and 2
More than
OFF 1 and 3
Less than
ON 1 and 3
S6M0096
B6M1406
Standard
1 Ω
1 Ω
1 MΩ
1 Ω
1 MΩ
1 Ω