Subaru IMPREZA GD 2007 Series Manual page 4145

asieps_tobira_IM_US.book 49 ページ ２０１２年１月１７日 火曜日 午後３時４８分
24.Security Control Unit
A: NOTE
The control of the security system is performed by the keyless entry control module.
B: REMOVAL
<Ref. to SL-55, REMOVAL, Keyless Entry Control Module.>
C: INSTALLATION
<Ref. to SL-55, INSTALLATION, Keyless Entry Control Module.>
D: PROCEDURE
1. FUNCTION SETTING (ECM CUSTOMIZING)
1) Connect the Subaru Select Monitor to the data link connector.
2) Turn the ignition switch to ON.
3) On the «Main Menu» display screen, select {Each System Check}.
4) On the «System Selection Menu» display screen, select {Keyless Unit Mode}.
5) In the «Integ. unit mode failure diag» display screen, select {ECM customizing}.
6) Change the setting with the UP/DOWN keys and set with the [OK] key.
• List of function setting item (ECM customizing)
No. Data
1 Security alarm setup
2 Alarm monitor delay setting
3 Impact sensor setup
4 Impact sensor setup
5 Passive arming
Security Control Unit
Initial setting Customize
values setting
ON Security alarm (hazard, horn) activates.
OFF
OFF Security alarm in inactive condition
After the keyless lock operation, the alarm monitor starts after
the following delay time has passed.
ON
ON Delay time is 30 seconds.
OFF Delay time is 0 seconds.
Enabled when the Impact Sensor Setup is set to "ON". Impact
ON
sensor function becomes activated.
OFF
Impact sensor in inactive condition (Always set to OFF for
OFF
vehicles not equipped with the sensor.)
Vehicle is controlled in impact sensor equipped mode.
(Always set to "OFF" on vehicles that are not equipped with
ON the impact sensor. When set to "ON", hazard, horn or siren
OFF
will operate after doors are locked by the keyless entry sys-
tem operation (Alarm monitor start).)
OFF Vehicle is controlled in no impact sensor mode.
Disables the feature that automatically arms even when the
ON
user does not lock (arm) intentionally.
OFF
OFF Enabled when passive arming is set to "ON".
SL-49
SECURITY AND LOCKS
Remarks