CRUISE CONTROL SYSTEM
5. Cruise Control Command
Switch
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the AB section for proper handling of the driv-
er's airbag module. <Ref. to AB-3, CAUTION,
General Description.>
1) Set front wheels in straight ahead position.
2) Turn ignition switch OFF.
3) Disconnect battery ground cable from battery
and wait for at least 20 seconds before starting
work.
®
4) Using TORX
BIT T30 (Tamper resistant type),
®
loosen two TORX
bolts which secure driver's air-
bag module.
5) Disconnect airbag module connector on back of
airbag module.
6) Remove horn switch from steering wheel as
shown.
CRUISE CONTROL COMMAND SWITCH
H5M0662A
S6M0095
7) Disconnect horn and cruise control command
switch connector, then remove cruise control com-
mand switch.
B: INSTALLATION
Install is in the reverse order of removal.
C: INSPECTION
Check continuity between cruise control command
switch terminals.
Switch
Position
CANCEL
SET/COAST
RESUME/
ACCEL
If NG, replace cruise control command switch.
CC-6
S6M0096
B6M1406
Tester con-
nection
ON
1 (+) — 2 (−)
ON
1 (+) — 3 (−)
OFF
1 — 3
No continuity
ON
1 — 3
OFF
1 — 2
No continuity
ON
1 — 2
Specified
condition
Continuity
Continuity
Continuity
Continuity