Subaru IMPREZA GD 2007 Series Manual page 4069

asieps_tobira_IM_US.book 5 ページ ２０１２年１月１７日 火曜日 午後３時４８分
General Description
SEAT BELT SYSTEM
B: CAUTION
• Before starting the work, turn the ignition switch
to OFF, disconnect the battery ground cable and
wait for 20 seconds or more.
• The pretensioner system has a backup power
source. Be careful that the pretensioner might de-
ploy if you do not wait for 20 seconds or more be-
fore starting work.
• Do not drop or apply any impact to the preten-
sioner.
• If oil, grease or water gets on the pretensioner,
wipe it off immediately with a dry cloth.
• Do not expose the pretensioner to high tempera-
ture or flame.
• Do not allow current to flow through or voltage to
reach the pretensioner. Do not use a circuit tester
to check resistance of the pretensioner.
• Do not disassemble or attempt to repair the pre-
tensioner. If it is dented, cracked or deformed, re-
place it with a new part.
• Do not use the airbag or pretensioner parts from
other vehicles. Always replace parts with new
parts.
• When handling a seat belt with deployed preten-
sioner, wear gloves and goggles. Wash your hands
afterwards.
• Do not reuse a seat belt with deployed preten-
sioner.
• If material from the airbag enters the eyes or con-
tacts skin during deployment, wash it away with
clean water, and then consult a doctor.
SB-5