Subaru IMPREZA GD 2007 Series Manual page 4181

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
10.Rear Wiper Motor
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear wiper arm. <Ref. to WW-16,
REMOVAL, Rear Wiper Arm.>
3) Remove the rear gate lower trim. <Ref. to EI-57,
REMOVAL, Rear Gate Trim.>
4) Unclip the clip of harness and disconnect con-
nector of wiper motor.
5) Loosen the bolts to remove the wiper motor as-
sembly (A).
6) Remove the rear wiper cushion.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Install the rear wiper pivot cap with the arrow
mark facing up, as shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to WW-3, REAR WIPER, COMPONENT,
General Description.>
Rear Wiper Motor
(A)
WW-00155
WW-00298
WW-17
WIPER AND WASHER SYSTEMS
C: INSPECTION
1) Connect the battery to the wiper motor connec-
tor and confirm that wiper motor operates.
2 1
4 3
2) Connect the battery to terminals of the connec-
tor, and remove the terminal connection with motor
rotating, and stop the wiper motor in mid-operation.
2 1
4 3
3) Connect the battery and confirm that the motor
stops at the automatic stop position after the motor
operates at low speed.
2 1
4 3
WW-00030
WW-00031
WW-00032