Subaru IMPREZA GD 2007 Series Manual page 4075

asieps_tobira_IM_US.book 11 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1. OUTER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• The parts of driver and passenger sides are
not the same. Before installation, make sure
that the correct part is used.
• Be careful not to twist the seat belts during
installation.
Tightening torque:
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
2. INNER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• After the driver's and passenger's inner seat
belt assembly installation, check that the seat
belt buckle switch operates normally using the
Subaru Select Monitor in {Status Data} of "Air-
bag System". <Ref. to AB(diag)-29, DISPLAY
OF STATUS INFORMATION, OPERATION, Sub-
aru Select Monitor.> Improper buckle switch
operation may cause airbag system malfunc-
tion.
• Inner seat belt assembly harness (1) must be
routed securely as shown in the figure, as it can
affect the performance of the seat position sen-
sor and occupant detection system.
• Driver's seat (with seat heater)
Front Seat Belt
• Driver's seat (without seat heater)
• Passenger's seat
(1)
Tightening torque:
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
SB-00327
SB-11
SEAT BELT SYSTEM
(1)
SB-00328
(1)
SB-00329