Subaru IMPREZA GD 2007 Series Manual page 4153

asieps_tobira_IM_US.book 57 ページ ２０１２年１月１７日 火曜日 午後３時４８分
31.Transmitter
A: REMOVAL
1. TRANSMITTER BATTERY
Remove the battery (1) from the transmitter.
NOTE:
To prevent static electricity damage to the transmit-
ter printed circuit board, touch the steel area of
building with hand to discharge static electricity car-
ried on body or clothes before disassembling the
transmitter.
B: INSTALLATION
1. TRANSMITTER BATTERY
Install in the reverse order of removal.
C: INSPECTION
1. TRANSMITTER BATTERY
Measure the voltage between the keyless transmit-
ter battery (+) terminal and (–) terminal.
NOTE:
Battery discharge occurs during the measurement.
Complete the measurement within 5 seconds.
(A) Resistance (47 Ω)
Tester connection
(+)
Battery Battery
Positive terminal Ground terminal
If NG, replace the battery. (Use CR2025 or equiva-
lent.)
Transmitter
(1)
SL-00387
(A)
SL-00066
Standard
(–)
2.5 — 3.0 V
SL-57
SECURITY AND LOCKS
D: REPLACEMENT
1. REGISTRATION OF KEYLESS TRANS-
MITTER WITH SUBARU SELECT MONITOR
NOTE:
• A maximum of four keyless transmitter can be
registered for each individual vehicle.
• When replacing or adding the keyless transmit-
ter, new registration of transmitter is necessary.
1) Connect the Subaru Select Monitor to the vehi-
cle.
2) Turn the ignition switch to ON.
3) From the «Main menu» of the Subaru Select
Monitor, select {2. Check individual system} →
{Keyless unit mode} → {1. Transmitter ID registra-
tion}.
4) Input the 8-digit ID number attached to the plas-
tic bag of the keyless transmitter or on the circuit
board inside the transmitter, from left to right, then
press the [Enter] key.
NOTE:
Press the [ ] key on the Subaru Select Monitor to
increase the number, and the [ ] key to decrease.
Press the [<] key to move to the digit in the left, and
[>] to the right.
5) The ID number you have entered will be shown.
Make sure that the ID number shown is the same
as that on the plastic bag.
6) If the ID number matches, select [OK]. If the ID
number is incorrect, select [NO] to return to the
step 3) and reenter the ID number.
7) «ID registration in process···» is displayed and
registration starts.
8) «ID registration done » will be displayed when
the registration process is done.
9) To exit, select «END: NO», to return to {1. Key-
less transmitter ID registration}. If there are addi-
tional keyless transmitters to be registered, select
«Next registration: OK» to return to the step 3).
NOTE:
• If the registration fails, «ID registration failed. Try
again.» will be displayed. Select the [OK] to return
to the {1. Transmitter ID registration}. And retry
from the step 2).
• «END: NO» will be shown on the Subaru Select
Monitor when the fourth keyless transmitter has
been registered. Select the [NO] key to return to {1.
Keyless transmitter ID registration}.