Connecting Devices; Part Names And Functions - YASKAWA MP3000 Series Setup Manual

2.3

Connecting Devices

This section explains how to connect devices to the MP3000-series Controllers.
2.3.1

Part Names and Functions

The following figure shows the names and functions of the parts of the Machine Controller and
the Servo Drive.
Machine Controller
 MP3200
DIP switch
(4 pins)
DIP switch
(6 pins)
USB
connector
If the CN1 and CN2 MECHATROLINK-III connectors and the Ethernet connectors are all used,
connecting and disconnecting the Ethernet connector at the bottom may be difficult. Therefore,
we recommend that you use the bottom Ethernet connector for devices that can normally be left
Note
connected.
Rotary switches (2)
Seven-segment display
Indicators (6)
Ethernet connectors
MECHATROLINK-III connectors (2 ports)

2.3 Connecting Devices

2.3.1 Part Names and Functions

2
2-37