Set Metric - Dell C9000 Series Reference Manual

set metric

To assign a new metric to redistributed routes, configure a filter.
C9000 Series
Syntax
set metric [+ | -] metric-value
To delete a setting, enter no set metric.
Parameters
+
-
metric-value
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
set automatic-tag
Commands
set level
(OPTIONAL) Enter + to add a metric-value to the redistributed
routes.
(OPTIONAL) Enter - to subtract a metric-value from the
redistributed routes.
Enter a number as the new metric value. The range is from zero
(0) to 4294967295.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
Access Control Lists (ACL) 382