Speed (Management Interface) - Dell S4810 Reference Manual

Version 8.3.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
This command is found on the 10/100/1000 Base-T Ethernet interfaces.
Information
When you enable auto, the system performs an automatic discovery to determine
the optics installed and configure the appropriate speed.
When you configure a speed for the 10/100/1000 interface, confirm the
negotiation auto command setting. Both sides of the link must have auto-
negotiation either enabled or disabled. For speed settings of 1000 or auto, the
software sets the link to auto-negotiation and you cannot change that setting.
Related
duplex (10/100 Interfaces)
Commands
the speed set to 10/100.
negotiation auto

speed (Management interface)

Set the speed for the Management interface.
S4810
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10
100
1000
auto
Interfaces
Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 or 100 Mbps, you can also use the duplex command.
— configures duplex mode on physical interfaces with
— enables or disables auto-negotiation on an interface.
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
Enter the keyword 100 to set the interface's speed to 10/100
Mb/s.
Enter the keyword 1000 to set the interface to auto-
negotiate its speed.
Enter the keyword auto to set the interface to auto-
negotiate its speed.
799