Ipv6 Nd Managed-Config-Flag - Dell Force10 S4810P Reference Manual

interface
interface
Command Modes
Command History
Version 8.3.7.0

ipv6 nd managed-config-flag

Set the managed address configuration flag in the IPv6 router advertisement.
E-Series
Syntax ipv6 nd managed-config-flag
To clear the flag from the IPv6 router advertisements, use the no ipv6 nd managed-
config-flag command.
Defaults 0
Command Modes INTERFACE
Usage The description of this flag from RFC 2461 (http://tools.ietf.org/html/rfc2461) is: M: 1-bit
information "Managed address configuration" flag. When set, hosts use the administered (stateful)
protocol for address autoconfiguration in addition to any addresses autoconfigured using
stateless address autoconfiguration. The use of this flag is described in: Thomson, S. and T.
Narten, "IPv6 Address Autoconfiguration", RFC 2462, December 1998.
1134
To remove all neighbor entries learned on a specific interface, enter
the keyword interface followed by the interface type and slot/
port or number information of the interface:
•
•
•
•
•
•
• EXEC
• EXEC Privilege
Introduced on the S4810.
For a Fast Ethernet interface, enter the keyword
fastEthernet followed by the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For a VLAN, enter the keyword vlan followed by the VLAN
ID. The range is 1 to 4094.