Ipv6 Nd Managed-Config-Flag; Ipv6 Nd Ns-Interval - Dell Networking 7048 Reference Manual

ipv6 nd managed-config-flag

Use the ipv6 nd managed-config-flag command in Interface Configuration
mode to set the "managed address configuration" flag in router
advertisements. When the value is true,
end nodes use DHCPv6. When the value is false, end nodes automatically
configure addresses.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
In the following example, the end node uses DHCPv6.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd managed-config-flag

ipv6 nd ns-interval

Use the ipv6 nd ns-interval command in Interface Configuration mode to set
the interval between router advertisements for advertised neighbor
solicitations. An advertised value of 0 means the interval is unspecified.
Syntax
milliseconds
ipv6 nd ns-interval
1071
IPv6 Routing Commands