Ipv6 Nd Managed-Config-Flag - Dell PowerConnect M6348 Cli Reference Manual

Syntax
attempts
ipv6 nd dad attempts
no ipv6 nd dad attempts
attempts — Probes transmitted. (Range: 0-600)
•
Default Configuration
The default value for attempts is 1.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets at 10 the number of duplicate address detection probes transmitted
while doing neighbor discovery.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd dad attempts 10

ipv6 nd managed-config-flag

Use the ipv6 nd managed-config-flag command in Interface Configuration mode to set the
"managed address configuration" flag in router advertisements. When the value is true,
end nodes use DHCPv6. When the value is false, end nodes automatically configure addresses.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
675