2) Click Login button leaving Password field blank or entering incorrect password. The Return to install Password Settings area appears. Click Browse button

and select the switch license file prepared in advance.

3) When you click Initialize button, the confirmation message appears. Click OK button. Then Login page opens. Enter the default password 'MeapSmsLogin' to

If you click Cancel button, the Login page opens without initializing the password.

11.1.22 Creating a Backup for MEAP Application Area, Formatting the Hard Disk, Restoring the MEAP Application Area with

the Backup, Using the SST (Service Support Tool)

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880

You can back up the area of the HDD where MEAP applications reside to a PC, as when you want to format the HDD. MEAP devices use a license-based mechanism

to control applications so that formatting the HDD will necessarily delete the jar files and application data, requiring you to not only reinstall them but also make

necessary settings. (Doing so consists in obtaining special license files for reinstallation and downloading user data/settings, increasing your work load.)

If you use the SST's backup function, you will be able to temporarily put aside the area of MEAP applications, thus being free of the foregoing extra work. This

function, however, is limited to a specific MEAP device (serial number), and cannot be used for illegal copying of applications.

You must not perform any other work (including checking operation) until the HDD has been backed up. This arrangement is to prevent a mismatch of MEAP

counter readings and the HDD contents, and any fault in operation arising as the result of failure to observe this will not be covered by the guarantee of operation.

Memo:

The application that is installed with a reusable license can be reinstalled by using the same license.

The following list shows the details of area that SST backs up;

Jar files of MEAP applications

Settings set with MEAP applications.

Note that SST does not back up images in Mailboxes that MEAP applications use.

User information data registered with SDL

Requirements for Backup Using the SST

The following conditions must be met for use of the function:

1) Device Firmware Version

iR2220 Series

iR2250 Series

iR5020 Series

iR5160 Series

Devices ither than those listed the above. Already supported since the 1st version. Already supported since the 1st version. The version supporting the

2) SST Version

Version 1.81 or later. An earlier version will not permit the use of the function. If needed, upgrade the SST.

3) Space for backup

11-30

Boot ROM

24.42 later

F-11-56

T-11-16

System

33.01 later

54.02 later

SST