Lacp Timeout - Dell PowerConnect W-7200 Series Reference Manual

lacp timeout

lacp timeout {long | short}
Description
Configure the timeout period for the LACP session.
Syntax
Parameter
long
short
Usage Guidelines
The timeout value is the amount of time that a port-channel interface waits for a LACPDU (Link Aggregation
Control Protocol data unit) from the remote system before terminating the LACP session. The default time out
value is 90 seconds (long).
Related Commands
Command
lacp group
show lacp
show lacp sys-id
show interface port-channel
Command History
Release
ArubaOS 3.4.1
Command Information
Platforms
All Platforms
392 | lacp timeout
Description
Enter the keyword long to set the LACP session to 90 seconds. This is the default.
Enter the keyword short to set the LACP session to 3 seconds.
Description
Enable LACP and configure on the interface
View the LACP configuration status
View the LACP system ID information
View information on a specified port channel interface
Modification
Command introduced
Licensing
Base operating system
Command Mode
Configuration Interface Mode (config-if) for
Master and Local controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide